Alan L
21st August 2005, 10:47 AM
Here is what you need to build a Front Diff for your 415/MS :-
Tamiya Parts
51055 - TRF415 Ball diff Pulley - as used on the rear.
53379 -3mm Lightweight Diff Ball Set - you can also use the Tungsten Carbide set (53124)
53030 - 850 Sealed Ball bearings. - only need 2 of the 4 from the packet
Yokomo Parts
ZS 501 - MR4 Diff Outdrives - There are 4 but you only need the 2 that centre the pulley.
ZS 506 - MR4 Diff Rings
ZS 507 - MR4 Thrust Race - needs to built up.
ZS 508 - MR4 Diff bolt & locking nut - Has 2 you only need 1. Then you have a spare.
If you don't have the lightweight suspension you will need to get the longer swingarms (51092 or 53724) - 46mm Swing Shaft.
Build the same as the rear diff.
Tamiya Parts
51055 - TRF415 Ball diff Pulley - as used on the rear.
53379 -3mm Lightweight Diff Ball Set - you can also use the Tungsten Carbide set (53124)
53030 - 850 Sealed Ball bearings. - only need 2 of the 4 from the packet
Yokomo Parts
ZS 501 - MR4 Diff Outdrives - There are 4 but you only need the 2 that centre the pulley.
ZS 506 - MR4 Diff Rings
ZS 507 - MR4 Thrust Race - needs to built up.
ZS 508 - MR4 Diff bolt & locking nut - Has 2 you only need 1. Then you have a spare.
If you don't have the lightweight suspension you will need to get the longer swingarms (51092 or 53724) - 46mm Swing Shaft.
Build the same as the rear diff.